Lightfast Water Concentrates

Application

Stir the contents well and always check the shade before application.

Wipe on Method – Take a clean, lint free cotton cloth or sponge and apply in the direction of the wood grain where possible. Take care to remove any excess stain immediately with a separate, clean absorbent cloth, again following the direction of the grain pattern. To obtain a uniform colour, always wipe evenly, blending the stain over the whole surface area by exerting a degree of pressure when applying by hand. Leave to dry, and do not sand between coats.

Sponge Applicator Method – Use a 7inch (or wider) Paint Pad Applicator (available from hardware stores or Fiddes Website) and a wide bucket or paint tray. Saturate timber following the direction of the grain working out a few boards/areas at a time. Use a paint brush to blend in end boards and leave.

Application videos are available on the Fiddes Australia YouTube Channel.

Dry Time

Hours at room temperature depending on application method

Coverage

15-25 sqm per Litre (depending on substrate and method of application)

Coats

1 coat – further coats will deepen colour/shade. (Leave for 24 hours between coats)

Thinners/Clean Up

Water

RECOMMENDED FOR USE ON

Fine Furniture, Doors, Floors, Cabinet Work and Panelling.